What is a panel upgrade?
A panel upgrade replaces your home’s main electrical panel, and often increases its capacity, so it can safely power everything you run today and plan to add. The panel is where power from the utility enters your home and splits into individual circuits, each protected by a breaker. When the panel is too small, worn out or outdated, everything downstream is affected.
Some upgrades are a straight replacement: same capacity, new equipment. Others raise the service size, for example from 100 to 200 amps, which can involve the meter base, the service wires and coordination with the electric utility. A load calculation decides which one your home needs, not a rule of thumb.
Why do Palm Beach County homes need panel upgrades?
Florida homes ask a lot of their electrical panels, because air conditioning runs most of the year on top of pool pumps, water heaters and kitchen appliances. Many homes in Palm Beach County were built decades ago, when a smaller panel was enough for the house as it was then. Add a second AC unit, a pool heater, an EV charger or a home office, and that original panel can run out of room.
Coastal conditions add wear. Salt air near the ocean and the Intracoastal corrodes outdoor meter bases, disconnects and exterior panels, and corrosion leads to loose connections and heat. Indoor panels in humid garages can show rust over time too. A panel that looks rusty, feels warm or smells hot needs attention, not paint.
Should I replace a Federal Pacific or Zinsco panel?
In most cases, yes: have it checked and plan on replacing it. Some Florida insurers ask about these brands at purchase or renewal, and both are widely flagged for reliability concerns.
Insurance is often what prompts a panel upgrade in Florida, because some insurers ask about the age and brand of a home’s panel at purchase or renewal. Certain older panel brands, such as some Federal Pacific and Zinsco models, are widely flagged because of reliability concerns, and homes with fuse boxes raise similar questions. If an insurer or home inspector asks for a replacement, an upgrade solves the problem and gives you a documented, permitted installation to show them.
What should I plan for when upgrading my panel?
The best time to plan for future electrical needs is during a panel upgrade, because adding capacity and breaker space once is simpler than reworking the panel later. If an EV charger, a pool, a generator or a remodel is on your list, mention it during the assessment so the new panel is sized and laid out for it.
A panel upgrade is also the natural time to add whole-home surge protection. A surge protective device mounts at the panel and helps protect appliances, air conditioning equipment and electronics from lightning and grid surges, which are a fact of life during Florida’s storm season.
Layout matters as much as size. A clearly labeled panel with spare breaker spaces makes every future project simpler, and it lets anyone in the home find the right breaker quickly during an outage or an emergency.
Can I replace an electrical panel myself?
Panel work is not a do-it-yourself project, because the wires coming in from the utility stay energized even with the main breaker off. Mistakes in breaker sizing, grounding or connections can cause overheating and fires that show up months later. Most panel replacements and service upgrades also need a permit and an inspection, which protects you when it’s time to make an insurance claim or sell the home.
Who upgrades electrical panels in Palm Beach County?
K&J Electrical Solutions does. We are a family-owned, owner-operated electrician in Palm Beach County, run by Jake and Kevin, and the two of them do the work themselves. We handle the load calculation, the permit where required and the install, and you deal with the owners from the first call to power-up. We work across the county, including West Palm Beach, Boynton Beach, Delray Beach, Boca Raton, Riviera Beach and Greenacres. Our phone is answered 24/7 at (561) 777-9982, or you can request an estimate.
