What is an electrical inspection?
An electrical inspection is a careful look at a home’s panel, wiring and devices to find safety problems, and a code correction is the repair that fixes them. The two often go together: someone points out an issue, and an electrician makes it right. K&J Electrical Solutions handles the correction side, for homeowners, buyers, sellers and landlords.
When do Palm Beach County homeowners need one?
Most electrical corrections start with a report from someone else. A home inspector working for a buyer may flag a panel, missing GFCI protection or exposed wiring. An insurer may ask about the panel or wiring type before writing or renewing a policy. A buyer or lender may require repairs before closing.
In each case the next step is the same: get a licensed electrician to look at the specific items and fix them. Bring the report so K&J can work from the exact wording.
What does a four-point inspection look at in the electrical system?
A four-point inspection is an insurance report that covers four systems, including electrical, and its electrical section focuses on the panel and wiring. Typically the inspector notes the panel type and condition, the kind of wiring in the house, and any visible hazards. Reports may flag certain older panel brands, fuse boxes, aluminum branch wiring or damaged wires.
K&J does not perform the four-point inspection itself. What K&J can do is correct the electrical items such a report flags, so the home can satisfy the insurer or buyer. If the panel is the problem, see panel upgrades. If the wiring is, see renovations and rewiring.
What are the most common electrical corrections?
Several issues come up again and again in Palm Beach County homes. Older panels reach the end of their useful life, and humid garages and coastal air corrode panels and outdoor equipment. Missing GFCI protection in kitchens, baths, garages and outdoors is a frequent flag, covered under outlets and GFCI. Others include double-tapped breakers, open junction boxes, missing cover plates, improper splices and DIY work left by previous owners.
Insurers also pay attention to the age of the home’s electrical system, so mid-century and older houses get extra scrutiny.
Does my older home need rewiring?
Older Palm Beach County homes often have wiring that reflects the era they were built in. Some mid-century homes have cloth-insulated wiring, whose covering can become brittle and crack with age and heat. Others have ungrounded circuits, which show up as two-prong outlets. A few homes have aluminum branch wiring, which needs special connection methods to stay safe.
None of these automatically means ripping out every wire. Depending on the condition, options range from targeted repairs and added grounding or GFCI protection to rewiring whole circuits or the whole house. An honest assessment comes before a recommendation. For outlet-level fixes, see outlets and GFCI.
What electrical work does a kitchen or bath remodel need?
Remodels almost always need new or changed circuits, because today’s kitchens and baths carry far more load than the ones they replace. A kitchen typically needs dedicated circuits for major appliances and multiple small-appliance circuits for the countertop, with GFCI protection where code requires it. Baths need protected outlets and adequate lighting circuits. Additions and garage conversions add load that the existing panel may not cover.
Plan the electrical early. Where outlets, lights and appliances go determines what gets run before drywall, and changes after walls close cost much more. If the new load is significant, a panel upgrade may belong in the same project.
Do I need a permit for rewiring or corrections?
Rewiring and new circuits are normally permitted and inspected through your city or county building department, and that process protects you. Inspectors check the work under the Florida Building Code and the National Electrical Code before walls are closed, and the record helps when you sell or file an insurance claim.
If a general contractor runs your remodel, K&J works with them: rough-in goes in before insulation and drywall, inspection comes next, and finish work follows once the walls are painted.
Who does electrical inspections and rewiring in Palm Beach County?
K&J Electrical Solutions does. We are a family-owned, owner-operated electrician in Palm Beach County, run by Jake and Kevin, and the two of them do the work themselves. Send us the inspector or insurer report and we will quote the specific items, or walk through your remodel plans before the walls close. We work across the county, including West Palm Beach, Lake Worth Beach, Delray Beach, Boca Raton, Riviera Beach and Palm Beach. Our phone is answered 24/7 at (561) 777-9982, or you can request an estimate.
