How much power does a Level 2 charger use?
A home Level 2 charger runs on a dedicated 240-volt circuit, usually between 20 and 60 amps. Because a car charges for hours at a time, the electrical code treats it as a continuous load, so the circuit must be rated at 125% of what the charger draws.
| Charger setting | Circuit and breaker it needs |
|---|---|
| 16 amps | 20 amps |
| 32 amps | 40 amps |
| 40 amps | 50 amps |
| 48 amps | 60 amps (hardwired) |
Most chargers let the installer set the maximum current, which is why the same charger can fit a big panel or a tight one.
How do I know if my panel has room?
A load calculation tells you. An electrician adds up what your home actually uses, from the AC and water heater to the range, dryer and pool pump, and compares it with your service size, usually 100, 150 or 200 amps. The panel also needs physical space for a two-pole breaker.
Signs that a panel is already working hard:
- Breakers trip when several large appliances run at once
- Lights dim when the AC or another big motor starts
- The panel is full, or uses tandem breakers to squeeze in circuits
- The panel or its breakers feel warm
What if my panel is too small?
You have more options than a full upgrade:
- Turn the charger down. A 32-amp setting on a 40-amp circuit still refills a typical day of driving overnight for most drivers.
- Add load management. An energy management device watches your home’s total load and slows the charger when the AC, dryer or range is running, so the panel never overloads.
- Use a charger with load sharing if you have two EVs, so both share one circuit.
- Upgrade the panel or service when the home needs more capacity anyway, for example if you are also adding a pool, a generator or another AC unit. See panel upgrades.
Does Florida heat change the math?
Yes. In Palm Beach County the air conditioner runs most of the year, often alongside a pool pump, so the panel has less spare capacity than the same home would have up north. A load calculation done for a Florida summer is the honest one.
Do I need a permit?
Usually, yes. Adding a 240-volt circuit is typically permitted through your city’s building department, or Palm Beach County in unincorporated areas, and inspected. A permitted install is also documented for insurance and resale.
What does it cost?
It depends on the distance from the panel to where you park, whether the panel has room, the charger you choose and the permit. We check your panel and the route before quoting, and the quote is free. Learn more about EV charger installation.
